Pitney Bowes DM230L - Manual (Page 45)

3-10 SV61891 Rev. A
3 • Running Mail
Processing and
Feeding Lettermail
on the DM350L
System
continued…
7. If the postage does not print on the envelope, it may have been
skewed when it entered the print area. If that occurs, you will get the
following error message in the display on the IntelliLink
TM Control
Centre:
“Mailpiece skewed
Reset... CE/C key”
Press the CE/C key on the control centre.
Feed the piece of mail again.
8. If the envelope stalls in the feeder or printer area, refer to the
Envelope Feeding Problems section in Chapter 7 of this guide.
NOTE: If you get the message "envelope stall" in the message display, try
pressing the Mail button to see if this feeds the envelope. You may get an
envelope stall message if for any reason the envelope does not reach the
sensor in the feeder within a certain time interval.