Pitney Bowes DM230L - Manual (Page 122)

SV61891 Rev. A 7-3
DM230L, DM330L, DM350L Operating Guide
Power Problems
No Display on
Control Centre;
Control Centre
Will Not Run 1. Is power cord plugged into both mailing machine base and wall outlet?
Make sure the power cord is not connected to a switched wall outlet.
2. Check power lamps on mailing machine base and control centre. Both
lamps should be on.
3. The control centre may be in sleep mode. Press any key to wake it.
Envelope Feeding Problems – DM230L/DM330L
Envelope Stalls
on Transport
Deck
HINT: If the
Control Centre
display prompts
“Remove Env” but
no envelope is
present, check if
there is a
partially-fed tape
on the feed deck.
To clear envelope:
1. Pull feed deck release
knob forward (A) and
lower deck as shown.
2. Carefully pull envelope
out from right (B).
3. Make sure deck is clear
of paper fragments.
4. Close deck.
To avoid envelope stalls:
1. Make sure your envelopes meet our published specifications.
See Chapter 1.
2. Feed envelopes correctly. See the instructions in Chapter 3. Don't try to
feed oversize envelopes through the machine. Use tape strips instead.