Pitney Bowes DM230L - Manual (Page 42)

SV61891 Rev. A 3-7
DM230L, DM330L, DM350L Operating Guide
4. Slide the envelope to the right
(B) until the system grasps it.
The system prints the postage
and ejects the envelope.
If you want to seal the envelope:
1. Hold the envelope ADDRESS SIDE UP.
2. Pull the flap slightly away from the envelope.
3. Slide just the flap under the blue edge of the feed deck as shown.
A brush below the deck wets the flap.
4. Slide the envelope to the right until the system takes hold of it.
The system prints the postage and ejects the piece.
5. To complete sealing, compress the envelope stack.
See Chapter 6 for instructions on refilling and maintaining the
moistener.
DM330L shown above.
Mail In a Minute
– Processing
a Letter Using
the Integrated
Weigh Platform
continued…