Pitney Bowes DM230L - Manual (Page 105)

6-2 SV61891 Rev. A
6 • Maintenance
Filling the
Moistener
1. Check the moistener tank to see
how much sealing solution is left.
2. Add enough E-Z Seal ® to bring the
sealant level up to the bottom of
the fill hole. We recommend E-Z
Seal
® Sealing Solution because it
helps keep your moistener clean
and improves sealing efficiency.
3. If the tank was empty, allow 30 minutes for the moistener brush and
wick to get completely wet.
CAUTION! Do not overfill the moistener tank.
Check Level Here Fill Here
The procedures for filling the moistener are different for the DM230L/
DM330L and the DM350L systems. Refer to the appropriate procedure in
this section.
The DM230L/
DM330L System