Pitney Bowes DM230L - Manual (Page 116)

SV61891 Rev. A 6-13
DM230L, DM330L, DM350L Operating Guide
You can adjust the position of the meter stamp with respect to the right
edge of the envelope. You might do this to compensate for thick envelopes
that present a stepped or uneven edge to the printhead. You can shift the
impression to the left or right as follows:
1. Press the Options key, then select Setup Menu.
2. Select Basic Setting, then Print Position.
3. Press 1 to shift the print position slightly to the left. Press again to shift
it more to the left.
4. Press 2 to shift the print position slightly to the right.
5. Press Enter when you’re done. The display shows the print position
you selected.
6. Test your setting by printing a zero ($0.00) postage amount on a
sample envelope. Check print quality and make sure the imprint is
where you want it.
NOTE: To achieve maximum readability of the digital indicia at Canada Post
we strongly advise that you do not change the default value that your system
is shipped with. Call your local post office or visit the Canada Post website at
www.canadapost.ca if you need more information.
Adjusting the
Print Position