Pitney Bowes DM230L - Manual (Page 118)

SV61891 Rev. A 6-15
DM230L, DM330L, DM350L Operating Guide
Replacing the
Printhead If print quality deteriorates and you cannot restore it using the print test
and maintenance procedures described in this chapter, please call service
or visit the Pitney Bowes web site. Refer to the Contacts section at the
front of this guide for more information.
Our telephone support representatives will help you isolate the problem.
CAUTION! Do not attempt to remove or replace the printhead unless
our support representatives advise you to do so. If necessary, they
will order a new printhead for you.
1. Press the Options key.
2. Select Setup Menu, then Advanced Functions.
3. Select Replace Printhead.
4. The display prompts you to read the
directions accompanying the printhead
and then to press Enter when ready.
If you don't want to replace the
printhead now, press the CE/C
(back) key.
5. Press the Yes key.
6. Open the front cover.
7. Press down on the printhead latch
release tab as shown in the figure (A).
Replacing the Ink
Cartridge
continued…
A
5. Close the rear cover.
6. Press the Options key twice.
7. Select Ink Functions.
8. Select Install new cartridge.
9. Press the Enter key. You can resume operation when the cartridge
initialization process is done.