Panasonic WJ-FS616C - Manual (Page 63)

63
■ Recording on the Time Lapse VCR
The following selections are made in the WJ-FS616C
SETUP MENU described previously.
Refer to the Recording Mode Setup on page 33 for further
details.
1. Check the selected recording mode (MODE 0 - MODE
9).
MODE 0: Normal Mode (Real Time)
MODE 1 - 9: Time Lapse Mode (Linear Mode)
If MODE 9 is selected, check the image (spot or
quad) to be recorded on the VCR.
2. Press the Record button of the VCR to begin recording.
Notes:
• To let the VCR display the VCR menu for setup,
select MODE 0 in the REC MODE SETUP menu of
the multiplexer.
• While recording with the camera switching pulse
(MODE 9), quad recording will work properly when
the selected recording interval is more than 0.11
seconds (less than 9 fields/s).
• While recording without the camera switching pulse
(MODE 1 – 8), quad recording is not available.
When using a VCR whose recording interval is 2 or
3 fields, select 4 fields (minimum) for the REC
MODE parameter.
However the same image may be recorded repeat-
edly.
■ Camera Switching Pulse Loss
Display
• When loss of the camera switching pulse is detected,
“SW LOSS” will blink on the monitor screen.
• The buzzer does not beep.
• When the camera switching pulse is recovered, “SW
LOSS” is cleared from the monitor.
Notes:
• When MODE 0 to MODE 8 is selected for recording,
or MULTI2 OUTPUT for REC/ MULTI2, “SW LOSS”
is not displayed because of the way the system
application works.
• If “ALARM” or “CH✽✽LOSS” is displayed on the
monitor screen, “SW LOSS” is not displayed
because alarm has priority.
OTHER FUNCTION