Panasonic WJ-FS616C - Manual (Page 78)

79
m=0 Quad m=1 7 divide
m=2 9 divide m=3 10 divide
m=4 13 divide m=5 16 divide
m=1 No. of divisions (+) m=D No. of divisions (
−
)
Item
Item
m=0 Manual Reset
m=1 Auto Reset
mm=00 - 16 Camera Number
*00=Spot Input
mm=01 - 16 Playback CH number
Alarm Input
Response
Command (ASCII)
● Command Table
(1) Operation Control
Transmission
Command (ASCII)
Parameter (ASCII)
Monitor Select OMS : m OMS
m=0 Spot Monitor
m=1 Multiscreen Monitor
m=2 Multiscreen 2 Monitor
VCR/Camera Select OVC : m OVC
m=0 Camera Mode
m=1 VCR Mode
Still ON/OFF OST : m : nn OST
m=0 Still OFF
m=1 Still ON
nn=00 All video channels specify
nn=01 - 16 Camera Number
Multiscreen Select OTC : m OTC
Sequence OSQ : m OSQ
m=0 End Sequence
m=1 Activate Sequence
Electronic Zoom
ON/OFF
OZM : m OZM
m=0 Zoom OFF
m=1 Zoom ON
Single Spot CH Select OCS : mm OCS
Camera & Playback Display
Playback CH Select
OVS : mm OVS
Alarm Reset OAL : m OAL
Alarm Log Clear OAR OAR None
Sequence Mode
Select
OSE : m OSE
m=0 SEQ1
m=1 SEQ2
m=2 SEQ3
OAI : m OAI
m=0 1CH Alarm
:
m=F 16CH Alarm
(2) Mode Change
Alarm Suspension MAD : m MAD
m=0 Alarm Suspension OFF
m=1 Alarm Suspension ON
Lock *1 MKL : m MKL
m=0 Lock OFF
m=1 Lock ON
Setup MSU : m MSU
m=0 End Setup
m=1 Begin Setup
Response
Command (ASCII)
Transmission
Command (ASCII)
Parameter (ASCII)
Note: If a command has no parameter value, it is processed with the value under lined in the table.
*1: The LOCK (key lock) command is used to prohibit operations on the panel of the Video Multiplexers and the System
Controllers. After execution of this command, only the personal computer can operate the system.