Panasonic WJ-FS616C - Manual (Page 71)

72
3. Press the [ZOOM] button to adjust the lens zoom to
achieve the desired image while observing the active
monitor.
Press this button to the [TELE] position to optically bring
an object closer.
Pressing to the [WIDE] position has the reverse effect.
4. Press the [IRIS CLOSE/OPEN] buttons to close/open
the lens iris. Adjust the lens iris by pressing these but-
tons to obtain the proper image exposure.
Pressing these buttons at the same time will reset the
lens iris to the factory default setting.
● Pan/Tilt Control (Manual Operation)
1. Select the desired monitor and camera referring to the
Camera Selection procedure described above.
2. Move the joystick to move the pan/tilt head in the
desired direction.
If the joystick is positioned in between UP and RIGHT,
the pan/tilt head moves diagonally upward and to the
right.
The moving speed of the pan/tilt head depends on the
tilt of the joystick.
● Pan/Tilt Control (Preset Operation)
The following function requires the use of cameras
equipped with the specific feature.
1. Select the desired monitor and camera referring to the
Camera Selection procedure described above.
2. Press the [PRE-POSI] button, then select the preset
position number by pressing the Numeric keys.
Camera Control Function
The camera control is only available while the camera
image is displayed in single spot on the selected monitor
screen.
Note: When controlling the camera with multiplexed control
data by connecting a coaxial cable, you should install
the optional WV-PB6164 Data Multiplex Board in the
video multiplexer.
■ Camera Selection
1. Select an either spot or multiscreen monitor by pressing
the [F2] or [F1] button on the controller.
2. Select the camera mode (VCR off) by pressing the [F4]
button on the controller.
3. Select the desired camera number by pressing the
Numeric keys, then press the [CAM(SET)] key.
The selected camera image is displayed in single spot
on the active monitor screen.
■ Controlling Camera Site Accessories
For controlling camera site accessories, normally combina-
tion camera equipped with the specific feature or a speci-
fied receiver are required to utilize these functions.
● Lens Control
Confirm that the specified lens with power zoom/focus func-
tions is mounted on the camera.
1. Select the desired monitor and camera referring to the
Camera Selection procedure described above.
2. Press the [FOCUS] button to adjust the lens focus to
achieve a sharply focused image while observing the
active monitor.
If the specified camera with auto focus feature is used
in the system, you can adjust the lens focus automati-
cally by pressing the [AF] button.
FOCUS
NEAR
FAR
AF
ZOOM
TELE
WIDE
CLOSEOPEN
IRIS
PRE-
POSI
1 2 3
4 5 6
7 8 9
MON CAM
UNIT/ESC SET
0