Pioneer PDV-LC10 - Manual (Page 73)

73
En
ADV
ANCED OPERA
TIONS
English
Various Digital Signal Settings
96 kHz PCM signal setting
96 kHz PCM is a high quality audio format with a far higher sampling frequency
than the 44.1 kHz format used for CDs. This format is used mainly for music
DVDs. There is no need to make this setting if the “Digital Jack” setting has
already been made with the Setup Navigator.
• 96 kHz 3 48 kHz: The 96 kHz signals
are down-sampled to 48 kHz before
being output. In this mode a Dolby
Pro-Logic amplifier or an amplifier
equipped with a digital input can be
used.
• 96 kHz: A 96 kHz compatible
amplifier or D/A converter is required
to select this mode.
This setting can be changed during
playback.
MPEG signal setting
MPEG is one audio format used with DVDs. There is no need to make this
setting if the “Digital Jack” setting has already been made with the Setup
Navigator.
• MPEG: An MPEG compatible
amplifier or D/A converter is required
to select this mode.
• MPEG 3 PCM: The MPEG signals
are converted into linear PCM audio
signals (48 kHz) before being output.
In this mode a Dolby Pro-Logic
amplifier or an amplifier equipped with
a digital input can be used.
This setting can be changed during
playback.
Settings: 96 kHz 3 48 kHz*
96 kHz
*Factory setting
Settings: MPEG
MPEG
3 PCM*
*Factory setting
Move Exit SETUP
DTS Out –
96kHz PCM Out
MPEG Out –
i
Audio1 General Language Other Video 2
Dolby Digital Out – Dolby Digital
Off
96kHz
3 48kHz
96kHz
Switch 96kHz audio output mode
Move Exit SETUP
DTS Out –
96kHz PCM Out –
MPEG Out
i
Audio1 General Language Other Video 2
Dolby Digital Out – Dolby Digital
Off
96kHz
3 48kHz
MPEG 3 PCM
MPEG
Switch MPEG audio output mode