PLUS Vision M-5 - Manual (Page 11)

11
1 2
1 2 3
[Reference] Method of installation for different wall materials
Select the type of installation best suited for the wall material.
If the wall is not strong enough, mount the copyboard to columns or studs.
Material of wall Method of installation
Wood Wood screws:
ቢOpen holes using a drill, then ባ mount the copyboard
using wood screws.
Concrete U-plugs:
ቢ Open the base hole in the wall using a drill, ባ insert the U-plug, then ቤ fasten the wall
mount bar using screws.
Steel Cross recessed tapping screw (pan head):
Check that there is reinforcement inside the steel wall, open holes with
a drill of the proper diameter, then mount the wall mount bar using tapping
screws.
1
2
3
3
(2) Fix the wall mount bar to the wall surface and
posts.
• Fasten the screws in a minimum of 3 places.
M6 wood screw
Mounting on the wall surface
M6 screw
Mounting on a post
Marker tray
Side covers
M4 x 8 screws
(3) Attach the marker tray to the Copyboard.
ቢ Insert the side covers into both ends of the marker
tray.
• Note that there are left and right type side covers.
ባ Temporarily fasten the three M4 x 8 screws into the
Copyboard (leaving about 3 mm)
• Use the supplied screwdriver.
ቤ Insert the marker tray over the 3 screws that have
been temporarily fastened, and then tighten securely.
• Please insert the marker tray as far as they will go.