PLUS Vision M-5 - Manual (Page 15)

15
Changing the
image storing
setting to “vertical”
Assembling
the stand
Mounting
the brackets
on the copyboard Mounting
the copyboard
onto the stand Mounting the
vertical marker tray
on the copyboard
Assembling the stand and mounting the copyboard vertically
Parts included in the copyboard package: 6 copyboard mount screws (M4 x 12)
List of parts included in the stand kit (parts used for vertical installation)
Feet (with casters) : 2, Frames : 2, Foot washers : 2, Foot fixing screws (M8 x 50) : 4,
Spring washers : 4, Caps : 6, Fixing knobs (with hexagon cap nuts) : 2, Crossbars : 2,
Hexagonal socket head screws : 4, Flat washers : 4, Upper brackets (left and right) : 2, Lower brackets : 2,
Hexagonal wrench (M8) : 1, Hexagonal wrench (M5) : 1, Short marker tray:1, Side covers: 2
M3 decorative screws : 2
bAssembly and installation flow
(1) Assemble the T-shaped legs (two).
ቢ Mount the foot using two M8 x 50 screws (+ spring
washers).
ባ Fit the caps on the top of the frame and feet.
(2) Mount the two crossbars onto the T-shaped legs
assembled in (1) above.
Mount them using the hexagonal socket head
screws and flat washers.
Temporarily fasten the screws using the included
hexagonal wrench, then fasten them securely once
both the upper and lower crossbars have been
mounted.
* Assemble in a flat place.
1
2
2
2
Cap
Frame
Cap
Cap
Spring
washer
Foot washer
M8 hexagonal wrench
M8 x 50 hexagonal
socket head screw
Foot
T-shaped leg
Crossbar
Crossbar
Flat washer
M5 hexagonal
socket head
screw
M5 hexagonal
wrench