PLUS Vision M-5 User Manual
Page 24
24
M
E
M
O
R
Y
W
E
R
F
E
E
D
/
S
T
O
P
POWER
FEED
/STOP
MEMORY
POWER
FEED
/STOP
M
E
M
O
R
Y
P
O
W
E
R
C
L
E
A
R
F
E
E
D
/
S
T
O
P
Ⅵ Saving sheet images on a CF memory card
Insert the CF memory card into the copyboard’s card slot.
• For instructions on inserting the CF memory card, see page 21.
Press the FEED/ STOP button to move the sheet image you want
to save to the front.
• There is no need to perform this operation to save the image that is cur-
rently at the front.
• When the FEED/STOP button is pressed, the sheet scrolls one page’s
worth to the left (or upwards) (this takes about 12 seconds), then stops
automatically. To stop in the middle, press the FEED/STOP button again.
Press the MEMORY button to store that image in the memory.
• The sheet scrolls one page’s worth to the left (or upwards), scanning starts,
then the image is stored on the CF memory card.
• The MEMORY indicator blinks slowly while the image is being stored in the
memory.
● If the indicator blinks intermittently
The indicator blinks intermittently (warning) when there is not enough free data
space left on the CF memory card.
*
Insert a CF memory card with enough free space on it, then press the MEMORY
button again.
*
To cancel the data storing procedure, press the FEED/STOP or POWER button.
If the indicator starts blinking intermittently (warning) after scrolling
*
The CF memory card may run out of space while the file is being stored. In this case, the data that was scanned is still
in the memory when the indicator starts blinking intermittently.
*
To store the data in a file, insert a CF memory card with enough free space on it, then press the MEMORY button.
*
Note that the data is discarded when the FEED/STOP or POWER button is pressed.
*
To save the same image again, bring that sheet surface back to the front, then press the MEMORY button.
Notice:
• Some time may be required for some CF memory cards to be recognized.
• The edges of the image on the sheet surface are not stored. See “Scannable area” on page 21.
• Some partions may not be read or their density built-in in the data may change (patchy letters, thin lines,
portions where marker lines overlap, etc.).
• Do not press the FEED/STOP button while the image is being scanned (while the MEMORY indicator is
blinking slowly). Doing so will cancel the data saving procedure and the data will be discarded.
• To move the sheet surface, press the FEED/STOP button after scrolling has stopped.
• The date of file property is fixed at January 1, 2004.
This can be changed using the “M-5 setup utility” function.
Removing the CF memory card
Check that the MEMORY indicator has stopped blinking and turned off, then pull
the CF memory card out.
Note: Do not remove the CF memory card while files are being stored (while
the MEMORY indicator is blinking slowly). Doing so will damage the data.
The CF memory card can be replaced while the MEMORY indicator is
blinking intermittently, indicating there is not enough free memory left.
Preparations: Check that the POWER indicator is lit. If it is off, press the POWER button.
The diagrams used in the explanations below show the
copyboard installed in the horizontal position.