PLUS Vision M-5 - Manual (Page 21)

21
Handling CF Memory Cards
• We recommend backing up data stored in the built-in memory or on CF memory cards onto other recording media
periodically to secure the data in case of damage or loss.
• Note that PLUS will accept no responsibility whatsoever for loss or damage of stored data.
• Please use a memory card having specifications that conform with the CompactFlash standard (which supports an
operating voltage of 3.3 V / 5 V).
* CompactFlash memory cards are referred to as “CF memory cards” in this manual.
MEMORY
POWER
CLEAR
PO SITIO
N
FEED /STOP
Inserting CF memory cards
b When using in the horizontal position
With the surface of the CF memory card facing the left, insert
the card vertically, pressing it slowly to the end.
ME MO RY
PO WE R
CLE AR PO SIT IO N
FEE D /S TO P
b When using in the vertical position
With the surface of the CF memory card facing the up, insert
the card horizontally, pressing it slowly to the end.
Note:
• Insert the CF memory card slowly.
• The slot is designed so the card cannot be inserted in the wrong
direction. Trying to force it will result in damage.
Removing the CF memory card
Check that the MEMORY indicator has stopped blinking and turned
off, then pull the CF memory card out.
Note:
• Do not pull off the CF memory card or disconnect the AC power
adapter’s cable while data is being stored in the memory (when
the MEMORY indicator is blinking). Doing so will damage the
data.
The CF memory card can be replaced while the MEMORY in-
dicator is blinking intermittently, indicating there is not enough
free memory left.
M E M O R Y
P O W E R
C L E A R
P O S IT IO N
F E E D
/ S T O P
ME MO RY
PO WER
CLE AR POSITION
FEE D /ST OP
Scanning area
Effective scanning area
Scanning is not possible on the edges of
sheet. Write or draw within the effective
scanning area.
Notice: The effective vertical scanning area
is within the ruled lines.
Notes on scanning the sheet surface
• When the POWER button is press to turn on the power or the
MEMORY button is pressed while in the standby mode, the
memory or feed operation starts after the warm-up. It is for stable
sanning condition.
Under normal conditions, it takes about 20 seconds, but under
certain environments, for example when the external temperature
is low, some more time may be required. On this copyboard, this
warm-up time is controlled by a timer and it can be changed with
the setup utility.
To achieve a more stable picture quality, we recommend you to
wait one minute after the fluorescent lamp turns on before storing
images in the memory. The time required for operation to become
stable depends on the environment.
• Note that images may not be read as well if you use markers of
colors other than black and red or markers of other brands. Use
the markers specified by PLUS.
• Avoid use in places exposed to abrupt changes in temperature
such as near the vents of an air conditioner.
Doing so could result in the deterioration of read quality.
20mm
23.5mm
23.5mm
20mm
578mm
978mm
Area not scannable
Effective scanning area