PLUS Vision M-5 - Manual (Page 14)

14
3
1
2
3
M4 ן12 screws
Lower bracket
Upper bracket (Left)
Upper bracket (Rightt)
M4
ן12 screws
M4 ן12 screws
Fixing knobs
Hexagon cap nuts
(4) Mount the upper and lower brackets using M4
x 12 screws.
• The left and right upper brackets are differ-
ent. Be sure to mount them on the proper
side.
• Both the lower brackets have the same
form, but mount them in the opposite di-
rections so that each is facing outwards.
(5) Hook the left and right upper brackets of the
Copyboard onto the upper crossbar and fas-
ten the lower brackets using the fixing knobs
and hexagon cap nuts.
CAUTION
• Lock the casters so that the stand does not move.
• When mounting and adjusting the height, at least
two people should hold the copyboard to prevent it
from dropping or tipping over, resulting in unex-
pected injury.
Marker tray
Side covers
(3) Attach the marker tray to the Copyboard.
ቢ Insert the side covers into both ends of the marker
tray.
• Note that there are left and right type side covers.
ባ Temporarily fasten the three M4 x 8 screws into the
Copyboard (leaving about 3 mm)
• Use the supplied screwdriver.
ቤ Insert the marker tray over the 3 screws that have
been temporarily fastened, and then tighten securely.
• Please insert the marker tray as far as they will
go.
M4 x 8 screws