PLUS Vision M-5 - Manual (Page 17)

17
3
1
2
3
Marker tray
Partition hanger
M4 screws
M4 screws
Mounting
the copyboard
on the partition Mounting
the marker tray
on the copyboard Mounting
the partition hangers
on the copyboard Mounting the hanger
brackets and hooks
on the partition hangers
Installing on a Partition-Panel
The optional partition hanger kit (Model M-5-P, order code 44-552) is required to install the copyboard on a partition-
panel.
Assembly and installation
b Assembly and installation flow
Parts included in the copyboard package : Marker tray (1 pc), side covers (2 pcs), M4 x 8 marker tray installation
screws (3 pcs, screws removed when unpacking)
List of parts included in the partition hanger kit
Partition hangers : 2, Hanger brackets : 2, Hooks : 2, M4 x 12 screws : 8 , M4 x 8 flat head screws : 4 ,
M4 x 6 screws : 4
(2) Mount the partition hangers onto the
copyboard (fasten at 4 spots).
Use the M4 x 12 screws (2 each).
Side cover
M4 x 8 screws
(1) Attach the marker tray to the Copyboard.
ቢ Insert the side covers into both ends of the marker
tray.
• Note that there are left and right type side covers.
ባ Temporarily fasten the three M4 x 8 screws into the
Copyboard (leaving about 3 mm)
• Use the supplied screwdriver.
ቤ Insert the marker tray over the 3 screws that have
been temporarily fastened, and then tighten securely.
• Please insert the marker tray as far as they will
go.