PLUS Vision M-5 - Manual (Page 37)

37
Windows 98SE Personal Computer and USB Connections
Driver Setup (Windows 98SE)
Note:
• Do not connect the Copyboard with the personal computer until Step .
• When using Windows Me, 2000, or XP, driver setup is not required. Make a USB connection with the Copyboard.
The Windows standard driver will be installed automatically.
• This driver does not support Windows 95 or NT, 2000 Server or Server 2003.
To make a USB connection with the Copyboard and a personal computer with Windows 98SE, please set up the driver
according to the following procedure.
Installation preparation
Please close application software that is running on the personal computer. Failure to close the applications
may result in installation problems.
Setup flow
Run the setup from
the supplied CD-ROM USB connection the
Copyboard
Driver installation check
Load the supplied CD-ROM into the CD-ROM
drive of the personal computer.
The menu screen will appear automatically.
• If the menu screen does not appear automatically, open
the CD-ROM and double click on "autorun.exe".
Click the [M-5 USB Driver]
The installer will start up. Follow the messages of the screen
and perform the installation.
Note: When the copyboard is connected before setup, a
screen requesting the driver will appear. Click "Cancel" and
disconnect the power cable of the unit.
Under these circumstances, restart the personal
computer following driver setup.
Making connections with the Copyboard
Connect the USB connector of the Copyboard with
that of the personal computer using a USB cable,
then plug the power cable into the power outlet.
• When connection is first made with the
Copyboard, the "New hardware addition wizard"
screen will appear. Please follow the instructions
on the screen.
• Please check that the Copyboard is operating
properly.