PLUS Vision M-5 - Manual (Page 16)

16
(3) Mount the upper and lower brackets
using M4 x 12 screws.
• The left and right upper brackets are different.
Be sure to mount them on the proper side.
(4) Hook the left and right upper brack-
ets of the Copyboard onto the up-
per crossbar and fasten the lower
brack-ets using the fixing knobs
and hexagon cap nuts.
There are two screw holes for adjusting
the angle (upright or 10 degrees) on each
lower bracket. Use the desired screw
holes.
CAUTION
• Lock the casters so that the stand does
not move.
• When mounting and adjusting the height,
at least two people should hold the
copyboard to prevent it from dropping or
tipping over, resulting in unexpected in-
jury.
(5) Mount the short marker tray.
ቢ Peel off the two cosmetic seals to expose the
screw parts.
ባ Insert the side covers into both ends of the short
marker tray.
• Note that there are left and right type side
covers.
ቤ Temporarily fasten the two M3 decorative
screws to the Copyboard (leaving about 3 mm).
ብ Insert the marker tray over the two screws that
have been temporarily fastened, and tighten se-
curely.
• Please insert the short marker tray as far as
they will go.
(6) Change the direction of image data (“PO-
SITION”) to “vertical”.
This sets the direction in which the images are
stored. (See page 25.)
Upper bracket
M4 x 12
screws
M4 x 12
screws
Lower bracket
Fixing knobs
Hexagon
cap nuts
To mount at a 10º angle
To mount upright
1
3
2
4
Short marker tray
Side covers
Cosmetic seals
M3 decorative screws