PLUS Vision M-5 - Manual (Page 13)

13
Installing on a Stand
The optional stand kit for both vertical and horizontal installation (Model M-5-T, order code 44-562) is required to
install the copyboard on a stand.
Assembling the stand and mounting the copyboard horizontally
Parts included in the copyboard package: Marker tray (1 pc), side covers (2 pcs), M4 x 8 marker tray installation
screws (3 pcs, screws removed when unpacking), 8 copyboard mount screws (M4 x 12)
List of parts included in the stand kit (parts used for horizontal installation)
Feet (with casters) : 2, Frames : 2, Foot washers : 2, Foot fixing screws (M8 x 50) : 4, Spring washers : 4,
Extension frames : 2, Caps : 6, Fixing knobs (with hexagon cap nuts) : 2, Crossbars : 2,
Hexagonal socket head screws : 4, Flat washers : 4, Upper brackets (left and right) : 2, Lower brackets : 2,
Hexagonal wrench (M8) : 1, Hexagonal wrench (M5) : 1
bAssembly and installation flow
Mounting the
copyboard
onto the stand
Assembling
the stand
Mounting
the marker tray
on the copyboard Mounting
the brackets
on the copyboard
1
2
3
3
3
Cap
Extension frame
Frame
Cap
Cap
Foot
Spring
washer
Foot washer
M8 hexagonal wrench
M8 x 50 hexagonal
socket head screw
T-shaped leg
Crossbar
Crossbar
Flat washer
M5 hexagonal
socket head
screw
M5 hexagonal
wrench
(1) Assemble the T-shaped legs (two).
ቢ Mount the foot using washers, spring wash-
ers and M8 x 50 hexagonal socket head
screws.
ባ Make sure of the orientation of the extension frame
and the frame end looking at the marks, then insert
all the way. (Note that it will no longer be possible to
remove the extension frame when the mark sur-
face has been inserted in the opposite orientation.)
Notice:
• Mounting the extension frame makes for a height
of 1700 mm off the floor (compared to 1465 mm
without the extension frame). Use this to adjust
the height.
• For the assembly procedure when not mounting
the extension frames, see step (1) under “Assem-
bling the stand and mounting the copyboard ver-
tically”.
ቤ Fit the caps on the top of the frame and feet.
(2) Mount the two crossbars onto the T-shaped
legs assembled in (1) above.
Mount them using the M5 hexagonal socket head
screws and flat washers.
Temporarily fasten the screws using the included M5
hexagonal wrench, then fasten them securely once
both the upper and lower crossbars have been
mounted.
* Assemble in a flat place.