Patton electronic 29XX - Manual (Page 223)

RIP Version 2 (Statistics) 223
Access Server Administrators’ Reference Guide 18 • RIP Version 2
Receive (rip2IfConfReceive)
This indicates which version of RIP updates are to be accepted. Note that rip2 and rip1OrRip2 implies recep-
tion of multicast packets.
• rip1 (1)—Accept RIP updates compliant with RFC 1058
• rip2 (2)—Accept multicasting RIP-2 updates
• rip1OrRip2 (3)—Accept both
• doNotRecieve (4)
Metric (rip2IfConfDefaultMetric)
This variable indicates the metric that is to be used for the default route entry in RIP updates originated on this
interface. A value of zero indicates that no default route should be originated; in this case, a default route via
another router may be propagated.
Status (rip2IfConfStatus)
Choosing invalid has the effect of deleting this interface.
• valid (1)
• invalid (2)
RIP Version 2 (Statistics)
The RIP Version 2 Status window (see figure 92 ) displays routing and update information for each subnet
address.
Figure 92. RIP Version 2 details window
Subnet IP Address (rip2IfStatAddress)
The IP address of the interface on the access server.
Bad Packets (rip2IfStatRcvBadPackets)
The number of RIP response packets received by the RIP process which were subsequently discarded for any
reason (e.g. a version 0 packet, or an unknown command type).
Bad Routes (rip2IfStatRcvBadRoutes)
The number of routes, in valid RIP packets, which were ignored for any reason (e.g. unknown address family,
or invalid metric).