Link compression (ppplinkcompression), Allow magic number negotiation (pppmagicnumber), Ppp statistics – Patton electronic 29XX User Manual
Page 285: Bad address (pppstatbadaddresses), Bad controls (pppstatbadcontrols), Packets too long (pppstatpackettoolongs), Lcp statistics, Local mru (pppstatlocalmru), Remote mru(pppstatremotemru), Local multilink mrru(pppstatlcplocalmrru)
WAN Circuit CONFIGURATION window
285
Access Server Administrators’ Reference Guide
23 • Sync PPP
Link Compression (pppLinkCompression)
This object enables the PPP link layer address and protocol field compression. When enabled the PPP negotia-
tions will DESIRE link compression but may disable the compression due the other end of the link not accept-
ing link compression. When disabled the PPP negotiations will FORCE no compression on the PPP link.
•
enabled(1)—enable link compression
•
disabled(2)—disable link compression
Allow Magic Number Negotiation (pppMagicNumber)
Determines if magic number negotiation should be done
•
enabled(1)—enable magic number negotiation
•
disabled(2)—disable magic number negotiation
PPP Statistics
This portion of the Dial In User Statistics window shows PPP statistics (as 32-bit variables) of the current user
selected.
Bad Address (pppStatBadAddresses)
The number of packets received with an incorrect address field.
Bad Controls (pppStatBadControls)
The number of packets received on this link with an incorrect control field.
Packets Too Long (pppStatPacketTooLongs)
The number of packets received that have been discarded because their length exceeded the maximum receive
unit (MRU).
LCP Statistics
This portion of the Dial In User Statistics window shows LCP statistics of the current user selected.
Local MRU (pppStatLocalMRU)
The current value of the MRU for the local PPP entity. This value is the MRU that the remote entity is using
when sending packets to the local PPP entity. This setting becomes active when the link is in the up—able to
pass packets—operational state
Remote MRU(pppStatRemoteMRU)
The current value of the MRU for the remote PPP entity. This value is the MRU that the local entity is using
when sending packets to the remote PPP entity. This setting becomes active when the link is in the up—able to
pass packets—operational state.
Local Multilink MRRU(pppStatLcpLocalMRRU)
Multilink maximum receive reconstruction unit for the local device.
Remote Multilink MRRU (pppStatLcpRemoteMRRU)
Multilink maximum receive reconstruction unit for the remote device.