Patton electronic 29XX - Manual (Page 324)

Configuring a leased line/dedicated line connection 324
Access Server Administrators’ Reference Guide C • Technical Reference
2. If you wish to apply the parameters specified in steps 1 and 2 based on WAN port then enter the appropri-
ate WAN port. Enter 0 if you want to apply the parameters based on number dialed only.
3. Enter the number dialed—this is not optional. Multiple phone numbers can be entered separated by semi-
colons (;).
Note The number dialed in the phone number received by the RAS from the
switch. Check the
Telco link on the Dial-in main window to verify the phone
numbers sent by the switch.
Configuring a leased line/dedicated line connection
The remote access server can connect to a remote modem for dedicated modem access.
Configuring the RAS
1. Configure the Line Interface Settings as usual for the T1/E1.
2. Configure the Signalling Settings using none(1) for Signal Mode . No other settings are necessary.
Figure 134. Signalling Settings window
3. Configure Channel Assignment for the T1/E1 setting each timeslot for which you want a dedicated con-
nection to leasedLine(4) .
Figure 135. WAN Circuit Channel Assignment window
4. Set Maximum V8 failures under Dialin->Modify Defaults in the Modem Configuration section. This will
configure the number of times the modem on the remote access server will attempt to dial out before stop-