Patton electronic 29XX - Manual (Page 292)

L2TP Configuration 292
Access Server Administrators’ Reference Guide 24 • Layer 2 Tunneling Protocol (L2TP)
RADIUS Authentication
Figure 121. L2TP RADIUS Authentication
When RADIUS Authentication is used, the following RADIUS attributes are used to configure the L2TP
Tunnel. The following information defines the RADIUS attributes which are supported, and example usage
from a RADIUS file, as well as a description of their operation:
--RadTunnelType, RADIUS Attribute: 64
example>> Tunnel-Type = 3,
The Tunnel-Type defines the type of tunnel used for this call. A value of "3" indicates L2TP as defined in
RFC 28668
--RadTunnelPassword, RADIUS Attribute: 69
example>> Tunnel-Password = "tunnel_pass",
This parameter defines the password which will be used to authenticate the tunnel. If no password is sup-
plied by the RADIUS server the tunnel will not use authentication on the tunnel link. Note that this is not
the password for the dialin user, or the PPP link, this will only be used to authenticate the tunnel.
RadServerEndpoint, RADIUS Attribute: 67
example>> Tunnel-Server-Endpoint = "192.168.200.15",
This is the IP address of the LNS. To define a different LNS server for a specific dialin user simply use a
new IP address. Multiple calls which will be sent through the same tunnel (same IP address) will always go
through the currently established tunnel (i.e. we do not create a new tunnel per call). we will establish a
new tunnel if a new remote LNS is defined by this parameter
RadTunnelClientID, RADIUS Attribute: 90
example>> Tunnel-Client-Auth-ID = "patton_lac",
If defined, this will be used as the "hostname" parameter supplied from the LAC to the LNS when the tun-
nel is being established. The cisco devices provide a command "terminate from" under L2TP. If this cisco