Panasonic KX-HGW600 - Manual (Page 17)

Operating Instructions
[For assistance, please call: 1-800-272-7033] 17
Set
u
p
2.2 Internet Configuration
2.2.1 Connecting to the Internet
Preparation
Before starting to install the KX-HGW600, make sure you have everything below.
• A Windows PC with a network card (Ethernet card or IEEE 802.11b wireless card)
installed
• Account information for Internet access (provided by your ISP)
• A CATV/xDSL/optical cable modem
Notes
• Some modems may store only the initial network information. They cannot
communicate with the other devices. Turn them off. After a while, turn them on
again.
• Some modems may need to be turned off for a few hours or even a whole day.
• Some ISPs prohibit you to turn off the modems. Please ask your ISP.
To collect information on the Internet access
Depending on the ISP, you can connect the following four types of Internet configuration.
• DHCP Connection
• Static Connection
• PPPoE (Point to Point Protocol over Ethernet) Connection
• PPPoE Connection (IP unnumbered)
Check the information provided by the ISP and make sure which type of configuration is
required. For more information, please ask your ISP.
To make note of corresponding account information for your future reference
1. DHCP Connection (using a DHCP server)
The DHCP server of your ISP assigns the IP addresses to the KX-HGW600
automatically. When the ISP uses the DHCP server function, enter Device
Name*, Gateway Address, DNS Server 1, DNS Server 2 and Domain Name
in the following data fields.
* Some ISPs may call Device Name differently. Please ask your ISP about
Device Name.
Device Name Gateway Address . . .
DNS Server 1 . . . DNS Server 2 . . .
Domain Name
✐✐
✐
✐✐