Panasonic KX-HGW600 - Manual (Page 99)

Operating Instructions
[For assistance, please call: 1-800-272-7033] 99
S
ystem
Featur
es
Instructions for the data fields
Entry Check Enabled or Disabled. When you check Enabled, the
entry works as specified. When you check Disabled, the
entry does not work but will work when you check Enabled
later.
IP Address (WAN) Enter the global IP address to send or receive data to/from
the WAN side.
Protocol Select the protocol(s) to send or receive data to/from the
WAN side. TCP, UDP, TCP&UDP, ICMP, PPTP or
are
available.
Forwarding Port No. Set the port number(s) to send or receive data to/from the
WAN side. Do not enter the space.
• When a single port is desired, set the port number.
• When a range of port is desired, enter the range using "-".
For example, to set the port numbers from 2000 to 3000,
enter as "2000-3000". The starting port number must be
lower in value than ending port number.
The port numbers from 60000 to 60016 are only available
for the KX-HGW600.
• When you select in the Protocol, be sure to enter " " in
this data field.
IP Address (LAN) Enter the private IP address of each device connected to the
KX-HGW600. A data from the WAN side is forwarded to the
IP address entered in this data field. In this case, set the IP
address of the corresponding Network Camera to this value.
IP Masquerade When multiple global IP addresses are assigned by the ISP,
enter one of them as the IP address for IP Masquerade
function. When it is set to blank, the IP address assigned on
the Basic Setup window or the IP address assigned by the
ISP is used.