Pioneer AVIC-Z3 - Manual (Page 152)

Setting the CD recording mode
You can set whether to start recording tracks
automatically when you play a CD, or to manu-
ally trigger recording.
% Touch [REC Mode] in System Settings
menu.
Each touch of [
REC Mode] changes the set-
tings as follows:
! Auto — Records the tracks automatically
when a CD is played
! Manual — Lets you select the tracks you
want to record manually, and records them
! Single — Automatically records only the
first track of the CD
Setting the rear output and
subwoofer controller
The navigation system
’s rear output can be
used for full-range speaker or subwoofer con-
nection. If you switch
Rear SP setting to
Sub.W, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
Initially, the navigation system is set for rear
fullrange speaker connection. When rear out-
put is connected to full-range speakers (when
Rear SP setting is Full), you can connect the
RCA subwoofer output (SUBWOOFER OUT-
PUT or NON-FADING OUTPUT) to a subwoofer.
In this case, you can select whether to use the
subwoofer controller
’s (low pass filter, phase)
built-in amp of the navigation system or the
auxiliary amp or subwoofer.
p If you change the subwoofer controller
[ Rear SP] or [Preout], [Sub Woofer] or
[ Non Fading] in Audio Settings menu re-
turn to the factory settings.
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
p Rear SP can be set only when the source is
[ OFF].
1 Touch [Rear SP] in System Settings
menu.
2 Touch [Full] or [Sub.W] to switch the
rear output setting.
p When no subwoofer is connected to the
rear output, select Full. When a subwoofer
is connected to the rear speaker leads di-
rectly, select
Sub.W.
3 Touch [Preout] to switch the subwoofer
output or non fading output.
p When [Rear SP] setting is Sub.W, [Preout]
is invalid.
p Even if you change this setting, there is no
output unless you turn [ Non Fading] or
[ Sub Woofer] in Audio Settings menu
[ On].
= For details, refer to Using non fading output
on page 145
= For details, refer to Using subwoofer output
on page 145
Switching the 5.1ch setting
When the navigation system is combined with
the multi-channel processor system (sold se-
parately), you can use the multi-channel
sound.
Enter the following setting when combining
the multi-channel processor system.
CAUTION
DO NOT enter this setting before you connect the
multi-channel processor system. (If this setting is
entered, the RCA (
“SUBWOOFER OUTPUT or
NON-FADING OUTPUT
”) will output maximum vo-
lume for the multi-channel processor system.)
Pioneer is not responsible for any damage to the
speaker equipment caused by ignoring this warn-
ing.
p This setting is possible only when the opti-
cal cable connection box (supplied with the
Multi-channel processor) is connected to
the navigation system.
1 Touch the source icon and then touch
[OFF] to turn source off.
When the source icon is not displayed, you
can display it by touching the screen.
Customizing the Audio Setting related with Audio Visual
En
152
Chapter
17