Pioneer AVIC-Z3 - Manual (Page 180)

Excess vertical installation
angle detected. Please install
the navigation unit correctly.
The navigation system is installed
with an extreme angle exceeding
the limitation of the installation
angle. Confirm the installation angle. (The naviga-
tion system must be installed within the al-
lowed installation angle. For details refer to
Installation Manual.)
No data available at this time. No data is available that can be
used with the XM tuner.
Wait for a while and try the operation again.
UPDATING (Updating) The selected channel is not in-
cluded in your subscription. Select another channel.
Radio is being updated with the lat-
est encryption code. Wait until the encryption code is fully up-
dated.
Route calculation was not
possible. Route calculation has failed be-
cause of a malfunction in map data,
software, or hardware. ! Change the destination.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Route calculation not possible
because destination is too far. The destination is too far. ! Set a destination closer to the starting
point.
! Set one or more waypoints.
Route calculation not possible
because destination is too
close. The destination or waypoint(s) are
too close. Set a destination and waypoint(s) farther
from the starting point.
Route calculation not possible
due to traffic regulations.
• The destination or waypoint(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the route
calculation is hampered.
! Set a destination and waypoint(s) outside
the CTR if you know where the restricted area
is.
! Try a destination or waypoint(s) away from
the currently set points to some extent.
! Drive your vehicle to an unrestricted area
and reset the destination and waypoint(s).
Route calculation not possible
because navigation cannot be
provided around destination
or starting point. The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible. ! Set a destination and waypoint(s) on roads.
! Reset the destination after you drive the ve-
hicle to any road.
Route to destination cannot
be calculated. The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear. Change the destination.
• Ferry could not be avoided.
• Toll roads could not be
avoided.
• Freeway could not be
avoided.
• Ferry, toll roads and free-
ways could not be avoided.
• Ferry and toll roads could
not be avoided.
• Toll roads and freeways
could not be avoided.
• Ferry and freeways could
not be avoided.
These messages appear when a
ferry route, toll roads, or freeways
are included in the route to the des-
tination or waypoints even though a
route is set to avoid them.
You can identify these condition by
the icons. If the current route is not desired, set destina-
tion or waypoints that do not pass through a
ferry route, toll roads, or freeways. (Page 32)
Appendix
En
180
Appendix