Pioneer AVIC-Z3 - Manual (Page 91)

The installation position of the navigation
system is shown. That indicates whether
the installation position of the navigation
system is correct or not. If installed cor-
rectly, [
OK] appears. When the navigation
system is installed at an extreme angle ex-
ceeding the limitation of the installing
angle, [
Incorrect angle] will be displayed.
When the angle of the navigation system
has been changed, [
Excessive vibration]
will be displayed.
5 Parking Brake
When the parking brake is applied, [ On] is
displayed. When the parking brake is re-
leased, [
Off] is displayed.
6 Power Voltage
The power voltage (reference value) pro-
vided from the vehicle battery to the naviga-
tion system is shown. If the voltage goes
out of the range from 11 V to 15 V, check
that power cable connection is correct.
7 Illumination
When the headlights or small lamps of a ve-
hicle are on, [
On] is displayed. When the
small lamps of a vehicle are off, [ Off] is dis-
played. (If the orange/white lead is not con-
nected, [
Off] appears.)
8 Back Signal
When the gear lever is shifted to
“R”, the
signal switches to [ High] or [Low]. (One of
these is displayed depending on the vehi-
cle.)
Checking sensor learning
status and driving status
1 Touch [Settings] in the navigation
menu, then touch [Hardware].
2 Touch [3D Calibration Status].
The 3D Calibration Status screen appears.
1
2
3
4
5
6
7
1 Distance
Driving distance is indicated.
2 Speed Pulse
Total number of speed pulses is indicated.
3 Learning Status
Current driving mode is indicated.
4 Degree of learning
Sensor learning situations for distance
(
Distance), right turn (Right Turn), left turn
( Left Turn) and 3D detection (3D) are indi-
cated by the length of bars.
p When tires have been changed or
chains fitted, turning on the Speed
Pulse allows the system to detect the
fact that the tire diameter has changed,
and automatically replaces the value for
calculating distance.
p If ND-PG1 is connected, the distance
calculation value cannot be replaced
automatically.
5 Speed
The speed detected by the navigation sys-
tem is indicated. (This indication may be
different from the actual speed of your vehi-
cle, so please do not use this instead of the
speedometer.)
6 Acceleration or deceleration/Rotational
speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
7 Inclination
Degree of slope of the street that you are
currently running is indicated.
Modifying the General Settings for Navigation Functions
En
91
Chapter
11
Modifying
the
General
Settings
for
Navigation
Functions