Using the hold (hold delay), For more detail the operation, refer to, Using the hold (hold – Roland VG-99 User Manual

Page 125: Delay), P. 125), Chapter 9, 125 fx (effects) chapter 9 parameters guide, Warp mod

Advertising
background image

125

FX (Effects) Chapter 9 Parameters Guide

Chapter 9

WARP

MOD

*

Recording and playback of performances and other operations are
carried out with pedals while Hold is in effect. Connect external pedals
(footswitches) or an FC-300.

1.

Referring to

“Using the Switches, Pedals, and MIDI to

Control the Sounds (CONTROL ASSIGN)”

(p. 82), assign the

following functions to the connected external pedals
(footswitches) or FC-300 CTL pedals.

2.

Set TYPE to HOLD in the Delay screen.

3.

Press the pedal to which REC is assigned.

Recording starts when you press the pedal.

4.

Press the pedal to which REC is assigned again to stop
recording.

*

The maximum recording time is 2.8 seconds. If the recording time
exceeds 2.8 seconds, the recording stops automatically, and the
recorded content is then played back.

*

An oscillating sound may be audible with extremely short recording
times.

5.

When layering recordings, repeat Steps 4 and 5.

*

The recorded content is cleared when the TYPE or patch is switched to
a different setting or when the power is turned off.

6.

To return to recording standby, press the pedal to which
STOP is assigned.

The unit returns to recording standby.

*

When playback is stopped, the recorded content is erased.

*

You can also set REC SW MODE to MOMENT.
If you use this setting, be sure to keep the pedal held down during
recording.

Parameter/
Range

Explanation

WARP SW

OFF, ON

Turns the WARP effect on/off.

This parameter is assigned to the
footswitch (CTL 1/2, CTL 3/4) and/or
FC-300’s CTL pedal.

RISE TIME

0–100

Adjusts how rapidly the warped delay
sound rises.

FEEDBACK DEPTH

0–100

Adjusts the feedback level of the warped de-
lay sound.

LEVEL DEPTH

0–100

Adjusts the volume of the warped delay
sound.

Parameter/
Range

Explanation

MOD RATE (Modulation Rate)

0–100

Adjusts the modulation rate of the delay
sound.

MOD DEPTH (Modulation Depth)

0–100

Adjusts the modulation depth of the delay
sound.

Using the HOLD (Hold Delay)

Controller

TARGET PARAMETER

SW MODE

CTL3, etc

[A] FX (or [B] FX)
DELAY (HOLD)
REC

LATCH

CTL4, etc

[A] FX (or [B] FX)
DELAY (HOLD)
STOP

- - -

VG-99_e.book 125 ページ 2007年7月5日 木曜日 午前9時22分

Advertising