Roland VG-99 - Manual (Page 28)

28
Chapter 2 Creating Sounds
10. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If you do not want to save, press [EXIT] to return to the Play screen.
* Although parameter assignments set with Control Assign are saved
with the Write procedure, the BEND parameter values in Step 8 are
not saved.
For detailed information on all the parameters, refer to
“ALTERNATE TUNING” (p. 116).
1. Press [ALTERNATE TUNING].
2. Press PAGE [ ] to go to Page 2.
fig.01-060d
3. Switch the function on or off with the F1 or F4
knob.
* You can make separate 12 STRING settings for COSM GUITAR
[A] and COSM GUITAR [B].
4. If making detailed parameter settings for 12
STRINGS, press [F1] (12STR) or [F4] (12STR).
5. Press PAGE [ ] [ ] to display the parameter
you want to set.
fig.01-060d
6. Set the desired parameter with [F1]–[F6] or
with the F1–F6 knobs.
7. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If you do not want to save, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
“ALTERNATE TUNING” (p. 116).
Example of BEND Parameter Settings
By making the parameter settings shown below, you can
achieve a string bender-like effect which smoothly raises the
pitch of the second string a whole step.
Values Set for the Alternate Tuning Parameter
[ALT TUNING]
AB LINK = ON
BEND SW = ON
BEND TUNING 1st = E 0
BEND TUNING 2nd = D +2
BEND TUNING 3rd = G 0
BEND TUNING 4th = D 0
BEND TUNING 5th = A 0
BEND TUNING 6th = E 0
Values Set for the Control Assign Parameter
[CONTROL ASSIGN]
SOURCE = FC-300 EXP 1 or RIBBON POS
(Set the RIBBON CONTROLLER’s ASSIGNABLE
setting to ON.)
SW = ON
TARGET PARAMETER = ALT TUNE/[A]BEND/BEND
Setting 12-STRING
VG-99_e.book 28 ページ ２００７年７月５日 木曜日 午前９時２２分