Roland VG-99 - Manual (Page 27)

27
Chapter 2 Creating Sounds
Chapter 2 1. Press [ALTERNATE TUNING].
2. Press PAGE [ ] to display Page 1.
fig.01-060d
3. Select A or B with [F2] (A/B) or the F2 knob.
* You cannot select this when AB LINK is on.
4. Switch the function on or off with the F3 knob.
5. Select the tuning TYPE with [F4] (TYPE) or the
F4 knob.
6. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If you do not want to save, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
“ALTERNATE TUNING” (p. 116).
1. Press [ALTERNATE TUNING].
2. Press PAGE [ ] to display Page 1.
fig.01-060d
3. Select A or B with [F2] (A/B) or the F2 knob.
* You cannot select this when AB LINK is on.
4. Switch the function on or off with the F5 knob.
5. Press [F5] (EDIT).
fig.01-060d
6. Set the pitches you want the strings to bend to
with the F1–F6 knobs.
7. Press PAGE [ ] to display Page 2.
fig.01-060d
8. Confirm the change in pitch with the F1 knob.
9. With Control Assign, set BEND as the target
parameter for the pedal being used to control
the pitch.
For detailed information on Control Assign, refer to
“Using the Switches, Pedals, and MIDI to Control the
Sounds (CONTROL ASSIGN)” (p. 82).
Setting TUNING
You can set original user tunings when USER is
selected for TYPE. (p. 29)
• Press [F3] (USER).
• Set the desired parameter with [F1]–[F6] or with the F1–F6
knobs.
• Press [EXIT].
Setting BEND
VG-99_e.book 27 ページ ２００７年７月５日 木曜日 午前９時２２分