Roland VG-99 - Manual (Page 186)

186
Chapter 10 Appendices
If there has been a mistake in an operation or if the operation is not
executed properly, an error message will appear in the display.
Please follow the instructions indicated in the message to resolve the
issue.
“DATA WRITE ERROR”
● Writing to the memory for storage of user data failed.
❍ The unit may be damaged. Consult the nearest Roland
service center.
“MIDI BUFFER FULL”
“RRC2 BUFFER FULL”
“USB BUFFER FULL”
● The data cannot be processed correctly due to the high
volume of MIDI messages.
❍ Reduce the volume of MIDI messages transmitted to the
VG-99.
“MIDI OFFLINE”
“RRC2 OFFLINE”
“USB OFFLINE”
● Transmissions from the connected device have been
interrupted. This message also appears when the power
to the connected device has been turned off. It does not
indicate damage.
❍ Check to make sure no cable is disconnected and that
there are no shorts.
“OUT OF RANGE! SET AGAIN”
● The D Beam controller or ribbon controller cannot be
calibrated.
❍ If using the D Beam controller, change the range or
position and recalibrate to keep this message from
appearing.
❍ If using the ribbon controller, confirm the calibration by
carrying out the procedure once more.
If the message continues to appear even after the
calibration is correctly performed, it may indicate
damage or malfunction. Consult your Roland dealer or
contact Roland Service.
“USB DEVICE ERROR”
● Initialization of the VG-99’s internal USB device failed.
USB cannot be used.
❍ The unit may be damaged. Consult the nearest Roland
service center.
If the VG-99 is not producing sounds or if you think it is not
operating properly, first check the following points. If checking these
points fails to resolve the problem, consult your dealer or the nearest
Roland service center.
For more on the USB drivers and problems when using
the drivers, refer to the following file contained on the
VG-99 Software CD-ROM.
No sound/Low volume
❏ Is there a short in any connecting cable?
→ Try replacing the connecting cable.
❏ Are the VG-99 and other devices connected properly?
→ Check the connections with the other devices (p. 16).
❏ Is the power to the connected amp or mixer not turned
on, or is the volume turned down?
→ Check the settings for the connected device.
❏ Is the OUTPUT LEVEL knob turned down completely?
→ Adjust the knob to an appropriate setting (p. 20).
❏ Is the tuner on?
→ The direct sound is not output when the tuner is on if the
volume setting during tuning is set to MUTE ON (p. 22).
❏ Is the [SYSTEM] - GK - GK CONNCT set properly?
→ If a Divided pickup is connected: set [SYSTEM] - GK -
GK CONNCT to ON (if AUTO does not function well).
→ If a Divided pickup is not connected: set [SYSTEM] - GK
- GK CONNCT to OFF.
❏ Is [COSM GUITAR A] or [COSM GUITAR B]
switched on?
→ No sounds from the Divided pickup will be played if
[COSM GUITAR] is switched off. Switch on the [COSM
GUITAR].
❏ Is [A/B BALANCE] set correctly?
→ Set [A/B BALANCE] for the channel in which sounds
are being played.
Error Messages Troubleshooting
OS Location
Windows XP \Driver\XP\Readme_E.htm
Windows Vista \Driver\Vista\Readme_E.htm
Mac OS X /Driver/Readme_E.htm
Problems with Sounds
VG-99_e.book 186 ページ ２００７年７月５日 木曜日 午前９時２２分