Roland VG-99 - Manual (Page 66)

66
Chapter 6 Using MIDI
Setting the MIDI Transmit Channel
(BASIC CH)
This sets the MIDI channel used for output of string performance
data from the VG-99.
Set the MIDI channels according to the POLY/MONO mode as
shown below.
• When set to POLY mode
The performance data for all of the strings is transmitted over
the basic channel.
• When set to MONO mode
1st string: Transmitted over the basic channel.
2nd string: Transmitted over the channel number one higher
than the basic channel.
:
6th string: Transmitted over the channel number five higher
than the basic channel.
For more details about the mode, refer to “Setting the
Transmission Mode (MODE)” (p. 67).
1. Follow Steps 1–2 in “Selecting the Controller
Used to Control the Hold Function (HOLD
CTL)” (p. 65) to display the GTR TO MIDI
screen.
2. Set the channel with [F3] (SELECT) or the F3
knob.
Preventing Transmission of Program
Change Messages (PC MASK)
You can prevent transmission of Program Change messages that can
be set in
“Outputting Program Change Messages
Simultaneously When Switching Patches (PC)” (p. 70).
* This does not affect such Program Changes as those set in “MIDI PC
OUT” (p. 60).
1. Follow Steps 1–2 in “Selecting the Controller
Used to Control the Hold Function (HOLD
CTL)” (p. 65) to display the GTR TO MIDI
screen.
2. Set the function to ON with [F4] (OFF/ON) or
the F4 knob.
When PC MASK is set to ON, the Program Change messages
set with the PC parameter (p. 70) in GUITAR TO MIDI are not
transmitted.
VG-99_e.book 66 ページ ２００７年７月５日 木曜日 午前９時２２分