Roland VG-99 - Manual (Page 146)

146
Chapter 9 Parameter Guide MIXER
Chapter 9 Parameter Guide
MIXER
This mixes the signals in Channel A and Channel B.
MIXER A, B (MIXER CHANNEL A, B)
PATCH LEVEL
TOTAL EQ
This adjusts the tone of the mixed signals from Channel A and
Channel B.
Parametric EQ is used for the low-middle and high-middle
frequency ranges.
MIXER
Parameter/
Range
Explanation
MIX SW
OFF, ON This setting switches mixing of Channel A
(or Channel B) on and off. The sounds in the
respective channel are not mixed when this
is set to OFF.
PAN
100:0–0:100 This sets the panning for Channel A (or
Channel B).
LEVEL
0–100 This sets the Channel A (or Channel B) vol-
ume level.
DELAY A SEND, DELAY B SEND
0–100 Adjusts the send level from Channel A (or
Channel B) to the mixer’s delay.
REVERB A SEND, REVERB B SEND
0–100 Adjusts the send level from Channel A (or
Channel B) to the mixer’s reverb.
CH DELAY (Channel Delay)
0–50ms Adjusts the time that the overall sound in
Channel A (or B) is delayed.
Although this is normally set to 0 ms, you
can produce greater breadth along with a
chorus effect by setting a difference in the
time the sounds are played relative to the
sounds from Channel B.
Parameter/
Range
Explanation
A/B BAL (A/B Balance)
A0:100B–A100:0B Adjusts the volume balance of Channel A
and Channel B. You can set this parameter
in the Mixer screen or with the BALANCE
knob.
This parameter is disabled when DYNAM-
IC is on.
PATCH LEVEL
0–200 Adjusts the overall patch volume.
Parameter/
Range
Explanation
EQ SW (Equalizer Switch)
OFF, ON Turns the EQ effect on/off.
TOTAL GAIN
-12–+12dB Adjusts the volume before the equalizer.
LOW GAIN
-12–+12dB Adjusts the low frequency range tone.
HIGH GAIN
-12–+12dB Adjusts the high frequency range tone.
LOW MID FREQ (Low Middle Frequency)
20Hz–10.0kHz Specifies the center of the frequency range
that will be adjusted by the LOW MID
GAIN.
LOW MID Q (Low Middle Q)
0.5–16 Adjusts the width of the area affected by the
EQ centered at the LOW MID FREQ.
Higher values will narrow the area.
LOW MID GAIN (Low Middle Gain)
-12–+12dB Adjusts the low-middle frequency range
tone.
HIGH MID FREQ (High Middle Frequency)
20Hz–10.0kHz Specifies the center of the frequency range that
will be adjusted by the HIGH MID GAIN.
HIGH MID Q (High Middle Q)
0.5–16 Adjusts the width of the area affected by the
EQ centered at the HIGH MID FREQ.
Higher values will narrow the area.
HIGH MID GAIN (High Middle Gain)
-12–+12dB Adjusts the high-middle frequency range tone.
VG-99_e.book 146 ページ ２００７年７月５日 木曜日 午前９時２２分