Roland VG-99 - Manual (Page 142)

142
Chapter 9 Parameters Guide COSM AMP
*1 Setting available when SP TYPE is set to CUSTOM.
Parameter/
Range
Explanation
SP TYPE (Speaker Type)
Select the speaker type.
OFF This turns off the speaker simulator.
ORIG This is the built-in speaker of the amp you
selected with PREAMP TYPE.
1x8” This is a compact open-back speaker cabinet
with one 8-inch speaker.
1x10” This is a compact open-back speaker cabinet
with one 10-inch speaker.
1X12” This is a compact open-back speaker cabinet
with one 12-inch speaker.
2X12” This is a general open-back speaker cabinet
with two 12-inch speakers.
4X10” This is an optimal speaker cabinet for a large
enclosed amp with four 10-inch speakers.
4X12” This is an optimal speaker cabinet for a large
enclosed amp with four 12-inch speakers.
8X12” This is a double stack of two cabinets, each
with four 12-inch speakers.
CUSTOM Custom speaker
DIRECT LEVEL
0–100 Adjusts the volume of the direct sound.
MIC TYPE
This setting selects the simulated mic type.
DYN57 This is the sound of the SHURE SM-57.
General dynamic mic used for instruments
and vocals. Optimal for use in miking guitar
amps.
DYN421 This is the sound of the SENNHEISER MD-
421.
Dynamic mic with extended low end.
CND451 This is the sound of the AKG C451B.
Small condenser mic for use with instru-
ments.
CND87 This is the sound of the NEUMANN U87.
Condenser mic with flat response.
FLAT Simulates a mic with perfectly flat response.
Produces a sonic image close to that of lis-
tening to the sound directly from the speak-
ers (on site).
MIC DIS (Mic Distance)
Simulates the distance between the mic and speaker.
Off MIC This setting points the mic away from the
speaker.
On MIC Provides conditions whereby the mic is di-
rected more towards the speaker.
Parameter/
Range
Explanation
MIC POS (Mic Position)
This simulates the microphone position.
CENTER Simulates the condition that the micro-
phone is set in the middle of the speaker
cone.
1–10cm Simulates the condition that the micro-
phone is moved away from the center of the
speaker cone.
MIC LEVEL
0–100 Adjusts the volume of the microphone.
Parameter/
Range
Explanation
CUSTOM SPEAKER *1
SIZE
5”–15” Selects the size of speaker.
LOW
-10–+10 Adjusts the speaker section’s low-frequency
tone.
HIGH
-10–+10 Adjusts the speaker section’s high-frequen-
cy tone.
NUMBER
x1, x2, x4, x8 Sets the number of speakers.
CABINET
Selects the speaker cabinet type.
OPEN This is an open-backed cabinet.
CLOSE This type of cabinet features an enclosed
rear panel.
VG-99_e.book 142 ページ ２００７年７月５日 木曜日 午前９時２２分