Roland VG-99 - Manual (Page 37)

37
Chapter 2 Creating Sounds
Chapter 2
This sets the signals and levels output for each of the VG-99’s output
jacks and connectors.
1. Press [MIXER].
2. Press PAGE [ ] to display Page 5.
3. Set the signal and level output to MAIN OUT,
SUB OUT, and DIGITAL OUT with [F1]–[F6] or
with the F1–F6 knobs.
For detailed information on the parameters that can be
set, refer to
“OUTPUT” (p. 147).
4. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If not saving the settings, press [EXIT] to return to the Play screen.
You can give names to the patches you create.
1. Press [NAME/KEY/BPM].
2. Press [F1] (NAME).
3. Press PAGE [ ] [ ] to move the cursor to
the position at which you want to change a
character.
4. Select the character with the PATCH/VALUE
dial.
As you continue to rotate the PATCH/VALUE dial, the
character guide automatically switches from uppercase letters
to lowercase letters, numerals, and symbols.
You can use the following convenient operations by pressing
[F1]–[F5].
5. Repeat Steps 3 and 4 to complete the patch
name.
6. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If not saving the settings, press [EXIT] to return to the Play screen.
Setting the Output Signal and
Level (OUTPUT)
You can also set the output signal and level for the
entire system.
1. Press [SYSTEM].
2. Press PAGE [ ] [ ] to display Page 2.
3. Press [F1].
4. Set the OUTPUT MODE parameter to
SYSTEM with [F1] or the F1 knob.
The value in the MIXER screen is disregarded, and
instead the SYSTEM value is applied.
The value in the MIXER screen is disregarded, and instead the
value < > is applied.
Naming a Patch (PATCH NAME)
Function
Button Description
[F1] (INSERT) Inserts a blank space at the cursor position.
[F2] (DELETE)
Deletes the character and shifts the charac-
ters that follow to the left.
[F3] (SPACE) Inserts a blank space at the cursor position.
[F4] (A0!)
Switches between letters, numerals, and
symbols.
[F5] (A<=>a)
Switches between uppercase and lower-
case letters.
[F6] (CATGRY)
Sets the category for the current patch. Re-
fer to
“Setting Patch Categories” (p. 90)
VG-99_e.book 37 ページ ２００７年７月５日 木曜日 午前９時２２分