Roland VG-99 - Manual (Page 35)

35
Chapter 2 Creating Sounds
Chapter 2
For detailed about the block diagram, refer to “Signal
Flow” (p. 183).
1. Press [MIXER].
2. Press PAGE [ ] to display Page 1.
Make the settings for each channel on this page.
* Page 2 and later pages contain the mixer section’s common settings.
3. Set the volume and panning with [F1]–[F6] or
with the F1–F6 knobs.
4. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If not saving the settings, press [EXIT] to return to the Play screen.
When mixing two channels, you can produce a more
realistic twin guitar tone by setting a channel delay in
one of the channels, thus causing the two guitar sounds
to be output at different times.
For detailed information on all the parameters, refer to
“MIXER” (p. 146).
You can set the balance in the mix of Channel A and Channel B with
the BALANCE knob. Soon after the knob is turned, the balance value
pops up in the screen.
* You can also adjust this parameter in Page 2 of the Mixer screen.
* This knob is disabled when the Dynamic function is switched on.
This sets the mixer section’s delay and reverb.
1. Press [DELAY/REVERB].
2. Press PAGE [ ] to display Page 1.
3. Switch the delay on or off with [F1] (OFF/ON);
switch the reverb on or off with [F4] (OFF/ON).
4. Set the parameters with [F1]–[F6] or with the
F1–F6 knobs.
* Each press of PAGE [ ] takes you to the settings screen for the
next parameter.
5. Adjust the parameters until you achieve the
desired sound.
6. If you want to save the edited settings,
perform the Write procedure (p. 38).
* If not saving the values, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
“DELAY/REVERB” (p. 148).
Mixing Two Tones (MIXER)
Setting the Volume and Panning
for Each Channel
Setting the Mix Balance
Setting the Delay and Reverb
(DELAY/REVERB)
VG-99_e.book 35 ページ ２００７年７月５日 木曜日 午前９時２２分