Roland CD-2 - Manual (Page 24)

24
Getting Started
Basic Operation
NOTE
• Once the connections have been completed ( Page
20), turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you
risk causing malfunction and/or damage to speakers
and other devices.
• This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required
before the unit will operate normally.
If No Other Equipment is Connected to
the CD-2
1
Turn counterclockwise to
“MIN” (minimum).
2
On the rear panel, press .
The power turns on. Once the power is on, the screen
lights up.
If Other Equipment is Connected to the
CD-2
1
Minimize the volume of all connected
devices.
2
Turn counterclockwise to
“MIN” (minimum).
3
On the rear panel, press .
The power turns on. Once the power is on, the screen
lights up.
4
Power up the device connected to the
AUX OUT jack.
If No Other Equipment is Connected to
the CD-2
1
Turn counterclockwise to
“MIN” (minimum).
2
On the rear panel, press .
The power turns off.
If Other Equipment is Connected to the
CD-2
1
Switch off the power on all connected
equipment.
2
Turn counterclockwise to
“MIN” (minimum).
3
On the rear panel, press .
The power turns off.
Turning the Power On/Off
Turning the Power On
CHECK
Make sure that the device connected to the
AUX OUT jack is powered off.
Turning the Power Off
CD-2.e.book 24 ページ ２００５年２月２０日 日曜日 午後４時２８分