Roland CD-2 - Manual (Page 30)

30
Recording to CF/CD
Recording with the Internal Mics
Here’s how to record a vocal or instrumental performance via
the CD-2’s internal mics (see the illustration below).
You can record to either a CF card or a CD-R/RW disc.
HINT
• You can check the amount of time that remains on the
media. Page 75, “Displaying the Remaining Time”
• You can increase the amount of free space on a CF card
or CD-RW by deleting unwanted tracks.
CF card Page 58, CD-RW disc Page 64
• If you’re recording to a CF card, you can select the
recording mode that’s appropriate for the content you’re
recording.
Page 36, “Choosing the CF Card
Recording Mode”
MEMO
• The sound from the internal mics will not be heard from
the internal speakers. You’ll need to use headphones in
order to audition the sound from the internal mics.
• Since the CD-2 is equipped with highly-sensitive mics,
undesired sounds such as the operating noise of the CD-
R/RW drive* or the sound of buttons being pressed may
be recorded inadvertently.
If you notice such problems, you can try lowering the
input level of the internal mics.
Page 37, “Adjusting
the Input Level: Internal Mic”
* If you’re recording to a CF card, no CD-R/RW drive
operating noise will be recorded.
• Depending on where the CD-2 is positioned in relation
to the sound source, the recorded sound may not be
evenly distributed between the left and right speakers. In
such cases, you can adjust the left/right volume balance
of the internal mics and record your performance
again.
Page 39, “Adjusting the Left/Right Volume
Balance of the Internal Mics”
1
Power up the CD-2.
Page 24, “Turning the Power On”
2
Make preparations for recording.
Insert a CF card or CD-R/RW disc.
Page 27, “Inserting a CF Card”
• If the message “Not CD-2 Format” appears,
format the card as described in “Preparing a CF
Card for Use.” (Page 36)
Page 26, “Inserting a Disc”
Press enough times to get it to
light in green.
This means that you’ll be recording the sound
from the internal mics.
Page 37, “Selecting the Recording Source”
Adjust the input level of the internal
mics.
● If Auto Level Control ( Page 76) is “On,” the
input level of the internal mics will be adjusted
automatically. You won’t need to adjust the
internal mic input level.
When the CD-2 is shipped from the factory, Auto
Level Control is turned “On.”
● If Auto Level Control is “Off,” you’ll need to
manually adjust the internal mic input level.
Page 37, “Adjusting the Input Level: Internal
Mic”
3
Press .
• Press the button for the media (CF card or CD) on
which you want to record.
The button starts blinking red, and the CD-2 enters
recording-standby mode.
4
Press .
• Press the button for the media (CF card or CD) on
which you want to record.
Recording begins.
5
When you’re finished recording, press
.
• Press the button for the media (CF card or CD) on
which you have been recording.
A new track is created at the end of the CF card or
CD-R/RW disc.
MEMO
• A CD-R/RW disc must be finalized before it can be
played back by a conventional CD player. Page 50,
“Make a Disc Playable in a Conventional CD Player”
1
2
3
CD-2.e.book 30 ページ ２００５年２月２０日 日曜日 午後４時２８分