Roland CD-2 - Manual (Page 26)

26
Getting Started
Inserting/Removing a CD
1
Press .
The disc tray opens.
2
Place the disc on the disc tray.
3
Press once again.
The disc tray closes.
• You can also close the disc tray by gently pressing
the front of the disc tray.
• You can also close the disc tray by pressing on
the CD side. When the disc is detected, playback
will begin automatically.
• When the disc has been detected, “CD” is indicated
as the audio source name.
In the case of a previously recorded disc or a music
CD, the total number of songs and the total
playback time will be displayed when this
information has been read from the disc.
1
Press .
The disc tray opens.
2
Remove the disc.
3
Press once again.
The disc tray closes.
• You can also close the disc tray by gently pressing
the front of the disc tray.
If pressing [EJECT ( )] fails to open the disc tray, you can
forcibly open the tray by pushing a straightened paper clip
into the emergency eject hole.
NOTE
• Never use the emergency eject hole to open the disc
tray while the CD-2 is operating.
1
Switch off the CD-2’s power.
Page 24, “Turning the Power Off”
2
Push a straightened paper clip (or similar
object) into the emergency eject hole.
The disc tray is ejected forcibly.
Pull out the disc tray, and remove the disc.
3
Push the disc tray closed.
Inserting a Disc
Disc tray
Place with the label surface
facing upward
Source name
Total number of tracks Total playback time
Removing a Disc
If the Disc Tray Doesn’t Open
Emergency eject hole
CD-2.e.book 26 ページ ２００５年２月２０日 日曜日 午後４時２８分