Roland CD-2 - Manual (Page 77)

77
More Functions
Here’s how to choose the audio source that will be output
from the CD-2’s rear panel AUX OUT jacks.
1
Press until “AUX OUT Select” appears
in the display, and then press .
• You can also select this item by turning [DATA].
The following screen appears.
2
Turn to select the audio source
that is output from the AUX
OUT jacks.
Mix: The audio of all sources is mixed and
output.
MIC: The audio from the MIC 1/MIC 2/GUITAR
jacks or the CD-2’s internal mics is output.
LINE: The audio from the LINE IN jacks is output.
CD: The audio from the CD is output.
CF: The audio from the CF card is output.
3
Press twice.
You’re returned to the previous readout.
Here’s how to adjust the output level of the AUX OUT jacks.
1
Press until “AUX OUT Level” appears
in the display, and then press .
• You can also select this item by turning [DATA].
The following screen appears.
2
Turn to select “Variable.”
Fixed: The output level is fixed.
The audio signal selected for “AUX OUT
Select” (
Page 77) is output at nominal
level.
Variable: The [OUTPUT LEVEL] knob will adjust the
output level.
3
Press twice.
You’re returned to the previous readout.
Use the [OUTPUT LEVEL] knob to adjust the output
level of the AUX OUT jacks.
Adjusting the Output Level from the AUX OUT Jacks
Choosing the Audio Source that is Output
from the AUX OUT Jacks Adjusting the Output Level of the AUX OUT
Jacks
HINT
• If you want to record your performance on an
electronic piano together with your voice, make
connections as shown below so that the sound from
the mic will also be output from the speakers of the
electronic piano.
At this time, set AUX OUT to “MIC” to prevent a
feedback loop from occurring between the CD-2 and
the electronic piano.
Mic
CD-2
LINE IN
MIC 1 or MIC 2
AUX OUT
INPUT
OUTPUT
Electronic piano
Other Functions and Settings
CD-2.e.book 77 ページ ２００５年２月２０日 日曜日 午後４時２８分