Roland MC-909 - Manual (Page 71)

71
Rhythm Edit
Patch/Sample Mode
Wave
These parameters select the PCM waveform that is to form the basis of the rhythm tone, and apply effects to the waveform.
Parameter Value Description
Wave Group INT, SRX, PRES,
USER, CARD Group of the waveform upon which the rhythm tone is to be based
INT: Waveforms stored in internal memory
SRX: Waveforms stored in a wave expansion board
PRES: Preset sample waveforms
USER: User sample waveforms
CARD: Card sample waveforms
* SRX can be selected only if a wave expansion board is installed.
Wave No. L/MONO 0 (OFF)–693 Waveform upon which the tone is to be based
On the MC-909 you can specify a separate waveform for the L and R channels.
* If you want to use the same waveform for the L and R channels, set the R channel to 0 (OFF).
Wave No. R
Wave Gain -6, 0, +6, +12 dB Waveform gain (amplitude)
The value will change in steps of 6 dB (decibels). An increase of 6 dB will double the gain. If you
want to use the booster to distort the sound, it is effective to set this to the maximum.
FXM (Frequency Cross Modulation)
FMX creates a complex overtone structure by using a specific waveform to frequency-modulate the selected waveform. This is suitable for cre-
ating extreme sounds or sound effects.
Wave FXM SW
(Wave FXM Switch)
OFF, ON Selects whether FXM will be used (ON) or not (OFF)
Wave FXM Color
(Wave FXM Color) 1–4 Selects how FXM will apply frequency modulation.
Increasing this value will produce a rougher sound. Decreasing this value will produce a more
metallic sound.
Wave FXM Depth
(Wave FXM Depth) 0–16 Depth of frequency modulation applied by FXM
MC-909_Ref_e.book 71 ページ ２００５年３月１日 火曜日 午後３時２９分