Roland MC-909 - Manual (Page 89)

89
Effects
Effects
If you change the “Output Assign” setting, the routing connections
in the screen will also change.
Parameters 4–11 in the above table are linked with the identically
named parameters in the setting screens of each effect.
Compressor
The compressor is an effect that limits the level of loud sounds and
boosts the level of soft sounds, making the overall level more
consistent.
fig.4-03
7.
MFX1 Reverb
Send Level
0–127 Depth of reverb applied to the
sound processed through
multi-effects 1
Set this to 0 if you don’t
want to apply reverb.
8.
MFX1 Output
Assign
DRY, MFX2 Output destination of the
sound processed through
multi-effects 1
DRY: MIX OUTPUT jacks
MFX2: Multi-effects 2
(multi-effects 1 and 2 will be
connected in series)
9.
(MFX Type)
See “Multi-Ef-
fects List” (p.
92) The effect used by multi-ef-
fects 2
* For details on each effect,
refer to “Multi-Effects List”
(p. 92).
10.
MFX2 Reverb
Send Level
0–127 Depth of reverb applied to the
sound processed through
multi-effects 2
Set this to 0 if you don’t
want to apply reverb.
11.
(Reverb Type)
See “Reverb”
(p. 90) The type of reverb
* For details on reverb, refer
to “Reverb” (p. 90).
Parameter Range Explanation
Parameter Range Explanation
Comp Reverb
Send Level 0–127 Depth of reverb applied to the
sound processed through the
compressor
Set this to 0 if you don’t
want to apply reverb.
Comp Output
Assign DRY, MFX1,
MFX2 Output destination of the
sound processed through the
compressor
DRY: MIX OUTPUT jacks
MFX1 (2): Multi-effects 1
(or 2)
Attack Time 0.05–50 ms Time from when the volume
goes up the threshold level
until the compressor effect ap-
plies
Release Time 0.05–2000 ms Time from when the volume
falls below the threshold level
until the compressor effect no
longer applies
Threshold 0–127 Volume level at which com-
pression begins
Ratio 1:1–inf:1 Compression ratio (inf: infini-
ty)
Output Gain 0– +24 dB Level of the output sound
Low Freq 200, 400 Hz Reference frequency of the
low range
Low Gain -15– +15 Amount of low-range boost/
cut
High Freq 2k, 4k, 8kHz Reference frequency of the
high range
High Gain -15– +15 Amount of high-range boost/
cut
Level 0–127 Output volume of the com-
pressor
MC-909_Ref_e.book 89 ページ ２００５年３月１日 火曜日 午後３時２９分