Roland MC-909 - Manual (Page 98)

98
Multi-Effects List
22: STEP FLANGER
This is a flanger in which the flanger pitch changes in steps. The
speed at which the pitch changes can also be specified in terms of a
note value based on a specified tempo.
fig.MFX22
23: OVERDRIVE
Creates a soft distortion similar to that produced by vacuum tube
amplifiers.
fig.MFX23
24: DISTORTION
Produces a more intense distortion than Overdrive. The parameters
are the same as for “23: OVERDRIVE.”
fig.MFX24
Parameter Value Description
Pre Delay 0.0–100.0
ms Adjusts the time until the flanger
sound is heard.
Rate 0.05–10.00
Hz, note Frequency of modulation
Depth 0–127 Depth of modulation
Feedback
#2 -98– +98 % Adjusts the amount of the flanger
sound that’s fed back into the effect.
Negative (-) settings invert the
phase.
Step Rate
#1 0.10–20.00
Hz, note Rate (period) of pitch change
Phase 0–180 deg Spatial spread of the sound
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Balance D100:0W–
D0:100W Volume balance between the direct
sound (D) and the flanger sound
(W)
Level 0–127 Output level
R in R out
L in L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger
Parameter Value Description
Drive #1 0–127 Amount of distortion
Also changes the volume.
Tone #2 0–127 Sound Quality
Pan L64–63R Stereo location of the OVERDRIVE
output
Amp Sw OFF, ON Amp simulator on/off
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double-stack amp
3-STACK: large triple-stack amp
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Level 0–127 Output level
Amp
Simulator
2-Band
EQ
L in
R in
Over
drive
L out
R out
Pan R
Pan L
L in
R in
L out
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Distortion
MC-909_Ref_e.book 98 ページ ２００５年３月１日 火曜日 午後３時２９分