System, Chapter 5 – RCA 608WL User Manual

Page 119

Advertising
background image

Chapter 5

Expert Configuration

E-DOC-CTC-20041126-0013 v1.0

117

System

The System category shows detailed system information of your SpeedTouch™:
In addition to the information shown already on the

System Information

page,

following detailed hard- and software information is provided:



The CLI parser version of the currently running SpeedTouch™ system software



The bootloader version of your SpeedTouch™ initial startup operating system



The hardware ASIC version of your SpeedTouch™’s core CPU

LAN

The LAN section provides per physical interface information on:



Its current operational mode:



Mode

, indicating the operation status of the interface



Auto Negotiation

, indicating whether the Ethernet connection mode is

negotiated or manually configured.



Ethernet operation Type, indicating



The operating speed (10/100 Mbps)



Ethernet connection mode (Half-/Full-Duplex)



Ethernet activity:



kBytes Tx/Rx

, indicating the amount of sent/received kilo Bytes.



Frames Tx/Rx

, indicating the number of sent/received Ethernet frames



Discarded frames

), indicating the number of discarded Ethernet frames.

WAN

The WAN category is subdivided into two sections: DSL and Connections.



The DSL section provides detailed information on the characteristics, state and
properties of the synchronized DSL line and properties and statistics on actual
condition of the DSL line.



The Connections section provides per WAN connection a detailed overview of
the connection's characteristics, IP connection parameters, Packet Service
specific parameters, and ATM specific settings and statistics for your Internet
connection services.

To check the IP connectivity of all connections, click

IP Connectivity

.

The results of the IP connectivity check are shown for each tested connection:

To change these settings, see

“5.5.3 Managed Switch” on page 176

.

If the result is ...

Then ...

IP connectivity was successfully checked on the
connection.

IP connectivity check failed (no response).

connectivity could not be determined for this
connection.

Advertising
This manual is related to the following products:

620