RCA 608WL - Manual (Page 121)

Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
119
Configuration This section allows you to view/configure remote destinations (syslog servers) to
send (a subset of) the SpeedTouch™ syslog messages for remote monitoring
purposes.
To add a destination:
1 Type a destination (IP address or host name) to send the messages to.
2 Click Add.
To change or delete a destination:
1 Select the applicable interface
2 If needed, make your changes and click:
 New
to add a new destination with the new settings next to the existing
one.
 Apply
to apply the changes to the existing destination.
 Delete
to remove the destination from the list of destinations.
Priority facility Following priority facilities are possible for a syslog message generated by the
SpeedTouch™. The facilities are listed by descending priority, each followed by
(notation, priority value):
 Kernel messages (kern, 0)
 User-level messages (user, 8)
 Mail system (mail, 16)
 System daemons (daemon, 24)
 Authorization messages (auth, 32)
 Syslog daemon messages (syslog, 40)
 Line printer subsystem (lpr, 48)
 Network news subsystem (news, 56)
 UUCP subsystem (uucp, 64)
 Clock daemon (cron, 72)
 Security messages (security, 80)
 FTP daemon (ftp, 88)
 NTP subsystem (ntp, 96)
 Log audit (audit, 104)
 Log alert (alert, 112)
 Clock daemon (clock, 120)
 Local use messages (local0 ... local7, 128 ... 184)
Click Deactivate to withdraw all forwarding of syslog messages for all
destinations; to re-enable forwarding of syslog messages, click Activate.