RCA 608WL - Manual (Page 23)

Chapter 1
Your SpeedTouch™
E-DOC-CTC-20041126-0013 v1.0
21
1.3.2 Access via CLI
Command Line
Interface (CLI)
You can access the Command Line Interface (CLI) via:
 The embedded Expert pages. For more information, see “5 Expert
Configuration” on page 107 .
 A Telnet session
This requires that TCP/IP connectivity exists between the host from which the
Telnet session is opened and the SpeedTouch™. Your SpeedTouch™ and the
connected PC must have an IP address in the same subnet.
 The serial ‘Console’ interface
 Quote site commands (over FTP)
For more information, see
“ Quote site command” on page 24 .
For information on CLI commands, see the SpeedTouch™ CLI Guide.
Telnet session Proceed as follows:
1 Open a telnet application.
2 Connect to your SpeedTouch™. .
3 Enter your SpeedTouch™ security user name and password.
4 As soon as you’ve opened a session to the CLI, the SpeedTouch™ banner is
displayed, followed by the CLI prompt, as shown in the example below:
You can use the Command Prompt window.
In Windows XP for instance:
1 On the Windows task bar, click Start.
2 Select (All) Programs > Accessories > Command Prompt.
In the Command Prompt window:
At the prompt, type
telnet
followed by the IP address of your
SpeedTouch™ (default is 192.168.1.254).
Username : Administrator
------------------------------------------------------------------------
* ______ SpeedTouch 620
* ___/_____/\
* / /\\ Version 5.3.0.20
* _____/__ / \\
* _/ /\_____/___ \ Copyright (c) 1999-2005,
* // / \ /\ \ THOMSON
* _______//_______/ \ / _\/______
* / / \ \ / / / /\
* __/ / \ \ / / / / _\__
* / / / \_______\/ / / / / /\
* /_/______/___________________/ /________/ /___/ \
* \ \ \ ___________ \ \ \ \ \ /
* \_\ \ / /\ \ \ \ \___\/
* \ \/ / \ \ \ \ /
* \_____/ / \ \ \________\/
* /__________/ \ \ /
* \ _____ \ /_____\/
* \ / /\ \ /___\/
* /____/ \ \ /
* \ \ /___\/
* \____\/
------------------------------------------------------------------------
{Administrator}=>