Add a new bridge port, Vlan, Vlan interface overview – RCA 608WL User Manual
Page 165: Vlan interface configuration, Chapter 5
Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
163
Add a new Bridge port
Proceed as follows to add a new port to the Ethernet Bridge:
1
Click New under the Bridge Ethernet overview table
2
In the Interface box, type a unique interface name; in the Destination list,
select the interface you want to use for this connection.
3
Mark the Multicast filter checkbox if you wish to filter out multicast streams on
this interface. In normal situations multicast packets are flooded on all ports of
the bridge, but this might cause unwanted performance issues on some
interface types.
4
Select the VLAN name to which arriving packets on this interface should be
assigned. In VLAN enabled mode this is only applicable for untagged packets.
5
Select the default Priority* to be used for tagging outgoing VLAN packets on
this interface.
6
Mark the Ingress Filtering* checkbox to filter out VLAN tagged packets that
arrive on an interface that has not the same VID as the packet.
7
Mark the Accept VLAN only* checkbox to no longer accept packets arriving on
this interface without a VLAN tag.
8
Choose your preferred Priority configuration from the list. This will make the
SpeedTouch™ to map the priority indication in the VLAN packet (IEEE 802.1p
value) to an internal priority class. This internal class can be taken into account
in other modules of the SpeedTouch™.
Disabled, to not perform priority mapping
Overwrite, to set the VLAN priority indication as the internal priority.
9
Click Apply.
VLAN
Next to transparent bridging, the SpeedTouch™ is also capable of operating in a full
VLAN ID aware mode. By using VLAN tagging, it is possible to make distinction
between different virtual networks residing on the same physical Ethernet segment,
and as such define different properties for them.
VLAN interface
overview
On the VLAN page, there is an overview of all VLANs that are defined in the
SpeedTouch™ (through the
pages) and the bridge ports that are member
of it.
VLAN interface
configuration
Proceed as follows to add or remove Bridged Ethernet interfaces for a certain VLAN:
1
Select the VLAN you wish to edit.
2
A listing of all bridge interfaces will appear, each followed by a drop-down list.
Change the value of the drop-down list to add or remove interfaces from this
VLAN:
(none)
, which means that this interface is not a member of the selected
VLAN.
Tagged
, which means that this interface is a member of the selected
VLAN, and that packets coming in and going out of the SpeedTouch™ will
be VLAN tagged.
Untagged
, which means that this interface is a member of the selected
VLAN, but that the VLAN functionality will be not visible outside the
SpeedTouch™. This means that inside the SpeedTouch™ VLAN will be
used to isolate interfaces from each other, but that outside of the
SpeedTouch™ no VLAN tagging will be used.
3
click Apply.
The
The parameters that are marked with an asterisk (*) are only applicable
when the SpeedTouch™ Ethernet bridge is in VLAN enabled mode.