RCA 608WL - Manual (Page 126)

Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
124
Switch to another
system software
version
To upgrade your SpeedTouch™ system software to a new version, or in some cases
roll-back to a previous version:
1 Make sure that a Passive system software is correctly uploaded to your
SpeedTouch™ (it should be listed in the Software Versions table).
2 Click Switch Over to restart the SpeedTouch™ and activate the passive system
software version as active version.
During restart, the SpeedTouch™ will switch the passive and active system software;
the previous active system software will be stored as passive system software
version.
!
Switching the system software versions may take a few minutes. Do
not power off your SpeedTouch™, or interrupt the switch process in
any other way.
If for any reason the switch-over failed, the system software version that
was running as active software version will be retained. To ensure correct
operation of the SpeedTouch™ after recovery, the previous passive system
software may need to be removed; instead the active system software will
be duplicated as passive system software version.