RCA 608WL - Manual (Page 151)

Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
149
Creating a NAT
mapping
Proceed as follows to create a address translation mapping:
1 Click New to create a new map.
2 Select or fill in all the fields (see above).
3 Click Apply.
Templates The Template page allows you to create a NA(P)T template.
Depending on your needs following fields are available:
 Interface
:
The name of the IP interface that needs to be NAT-ed.
 Group
:
The IP interface group scope for this template.
 Protocol :
The IP protocol on which address translation has to be applied. This allows the
SpeedTouch™ to link specific traffic (protocol dependent) to a chosen private
host.
 Outside address :
The outside (typically public) IP address(es).
 Inside address
:
The inside (typically private) IP address(es).
 Access list
:
You can use the access list to define the address(es) that are allowed to use the
outbound connections.
 Foreign address
:
Foreign address is to define the address (es) that are allowed to use the inbound
connections.
Creating a NAT
template
Proceed as follows to create a template:
1 Click New to create a new template.
2 Select or fill in all the fields (see above).
3 Click Apply.
If you selected NAPT, you will have to specify a port range for the inside and
outside address.